Low Test Current DC Low-OHM Meter
Best suitable for auto measurement for DCR of tip inductor / fuse resistance value
●Measurement range
: [% Measurement] 1mΩ～9.99mΩ/±50.0%
10mΩ～10kΩ/±50.00%
: [mΩ measurement] 0.00mΩ～15.000kΩ%
●Measurement not to influenced by
thermoelectromotive force.
●Available to measure without error by relay time setup
each range
●Circuit designed to eliminate contact error as much
as possible
●Contact-check is equipped as standard function.
●Comparison result by built-in comparator is
open-collector output and displayed by LED and buzzer.
●GP-IB/RS-232C/Centronics output available.(Option)
●Measuring current/ voltage-check are built-in as
standard function.
The Outline
AX-1155B is available to measure the super-low resistance with high speed and high accuracy from 0.00mΩ to 15.000Ω (% measurement :1mΩ～10kΩ)
In addition, it is possible to make the measurement the measuring object accumulately and stable, because they have DOUBLE MEASURING MODE and special AUTO-ZERO circuit that it is available to measure them after cancellation of thermoelectromotive force for error factor when the measurement is made low-resistance especially.
The checker is displayed the measured value, judged HI, GO, and LO, and then the signal is output.
The measuring speed is changeable and it is selectable AVERAGE/DOUBLE/SLOW etc.
And as CONTACT CHECK CIRCUIT and measuring current/abnormal voltage check circuit are equipped as standard, this checker become higher the confidence.
And it is available to equip the interface of GP-IB, RS-232C, or Centro Output as optional function.
Option
●GP-IB Interface ●RS-232C Interface
●Printer output (8 bit parallel Centronics) ●Printer cable
*Either one interface can built-in the option above.